   LAN Manager Workstation/Server

   Introduction:
   -------------
   This  document  describes  the  procedure  to   setup  LAN  Manager 2.1
   Workstation/Server driver for PCMCIA NE2000 ethernet adapter.

   Location of Driver:
           (DOS) \MSLANMAN.DOS\DRIVERS\ETHERNET\PCMND\PCMND.DOS
           (OS2) \MSLANMAN.DOS\DRIVERS\ETHERNET\PCMND\PCMND.OS2


   Sample Configuration Files:
   ---------------------------
      CONFIG.SYS (for DOS):

         DEVICE=C:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /I:C:\LANMAN.DOS
         DEVICE=C:\LANMAN.DOS\DRIVERS\ETHERNET\PCMND\PCMND.DOS

      CONFIG.SYS (for OS2):

         DEVICE=C:\LANMAN.OS2\DRIVERS\PROTMAN\PROTMAN.OS2 /I:C:\LANMAN.OS2
         DEVICE=C:\LANMAN.OS2\DRIVERS\ETHERNET\PCMND\PCMND.OS2


      PROTOCOL.INI (will contain):

         [PCMND_NIF]
         ; PCMCIA RPOTOCOL.INI SAMPLE

           DriverName = PCMND$

   Setup Procedures:
   -----------------
      Before you  start  with the installation process, make sure that the
      adapter  is properly  installed  and   configured.  Make  sure  your
      Microsoft LAN Manager is properly installed.

      1. Run the appropriate Microsoft Lan Manager SETUP for computer  you
         are setting up. Select ]Configuration] item , ( the PCMCIA driver
         isn't  included on  the  Lan Manager disk ) and insert the PCMCIA
         driver disk, select the PCMCIA driver and follow the directions.

      2. When completed, reboot your computer .

   Note
       After completion of the SETUP , you should modify the  PROTOCOL.INI
       file  to specify the INTERRUPT number  and the IOBASE number  which
       must be  equal to the /irq and /io parameters specified to the Card
       Enabler program.
